al wrist_sens_installed wsi Trendsetter_400/800_Auto If the version 3 picker is installed, but the wrist sensor introduced on ECO #D388 (100 label #24) is not installed, this parameter should be set to 0. Otherwise, it should be set to 1. The wrist sensor was introduced to improve the reliability of the version 3 picker. The sensor should be installed. This parameter was only added to avoid potential problems where the firmware was upgraded without a sensor being installed. In general, this parameter should always be 1 if a version 3 picker is installed. Otherwise, the firmware is not able to do the extra checks for picking problems. byte
  • 0
    •
  • 0 to 1
    •      Only supported in firmware versions 1.40 and above. cfg
  • ../commands/pick.xmlCommand: pick
  • ../commands/picker.xmlCommand: picker
  • ../nvs/al_cfg_vpi.xmlNVS: al vpi
    •
  • ..\..\ShowAllErrors.htmFirmware 0 Error Index
  • ..\..\ShowAllCommands.htmFirmware 0 Command Index
  • ..\..\ShowAllNVS.htmFirmware 0 NVS Index
    •  Updated: Wed Jul 16 19:36:01 2008 PST